泵及真空设备
进口自吸泵(欧美进口十大品牌)
2019-10-15 09:45  浏览:88
价格:¥0.00/台
品牌:英国格林
起订:1台
供应:100台
发货:30天内
发送询价
 英国GRIMM格林进口自吸 UK GRIMM imported self-priming pump

进口自吸泵.gif

英国GRIMM格林进口自吸泵概述: 

          进口自吸泵是根据英国格林有关技术资料经吸收、消化、改进后研制而成的节能泵类产品。该泵属自吸式离心泵,它具有结构紧凑、操作方便、运行平稳、维护容易、效率高、寿命长、并有较强的自吸能力等优点。管路中不需安装底,工作前只需保留泵体内储有定量引液即可。因此简化了管路系统,又改善了劳动条件。

英国GRIMM格林进口自吸泵结构说明及工作原理: 

             进口自吸泵,主要由泵体、叶轮后盖、机械密封、泵轴、轴承座、进口阀、气液分离管、加水阀门,进、排接管等 组成。
          泵的工作原理,该泵均采用轴向回液的泵体。原理由吸入室、储液室、涡卷室、回液孔、气液分离室等组成。
          泵正常起动后,叶轮将吸入室所存的液体及吸入管路中的空气一起吸入,并在叶轮内得以完全混合,在离心力的作用下,液体夹带着气体向涡卷室外缘流动,在叶轮的外缘上形成有一定厚度的白色泡沫带及高速旋转液环。气液混合体通过扩散管进入气液分离室。此时,由于流速突然降低,较轻的气体从混合气液中被分离出来,气体通过泵体吐出口继续上升排出。脱气后的液体回到储液室,并由回流孔再次进入叶轮,与叶轮内部从吸入管路中吸入的气体再次混合,在高速旋转的叶轮作用下,又流向叶轮外缘▪▪▪▪▪▪。随着这个过程周而复始的进行下去,吸入管路中的空气不断减少,直到吸尽气体,完成自吸过程,泵便投入正常作业。

英国GRIMM格林进口自吸泵技术参数: 

流       量:3.2-600m3/h
扬       程:8-80m
口       径:进口直径:25-300mm
                  出口直径:25-250mm
吸       程:5-6.5m
自吸性能:1.3-2.5min/5m
转       速:1450r/min、2950r/min
功       率:0.75-132kw

 

 

英国GRIMM格林进口自吸泵应用范围: 
1、适用于城市环保、建筑、消防、化工、制药、染料、印染、酿造、电力、电镀、造纸、工矿冲洗、设备冷却等。
2、装上摇臂式喷头、又可将水冲到空中后,散成细小雨滴进行喷雾,是农场、苗圃、果园、园的良好机具。
3、适用于清水、海水及带有酸、碱度的化工介质液体和带有一般糊状的浆料(介质粘度≤100厘珀、含固量可达30%以下)。
4、可和任何型号、规格的压滤机配套使用,将浆料送给压滤机进行压滤的zui理想配套泵种。

UK GRIMM imported self-priming pump summary:

         imported self-priming pump is based on the relevant technical data of the United Kingdom Green, absorbed, digested, improved, developed from energy-saving pump products. The pump is a self suction centrifugal pump. It has the advantages of compact structure, easy operation, stable operation, easy maintenance, high efficiency, long service life and strong self suction capacity. Do not need to install the valve in the pipeline, keep working just before the pump body fluid can be stored with quantitative cited. Therefore, the pipeline system is simplified and the working conditions are improved.

 

UK GRIMM imported self-priming pump structure description and working principle:

 

           imported self-priming pump, mainly by pump body, impeller rear cover, mechanical seal, pump shaft, bearing seat, inlet valve, gas-liquid separation pipe, water valve, intake, discharge pipe and so on.

        The working principle of the pump is that the pump adopts axial return liquid pump. The principle is composed of suction chamber, liquid storage room, scroll chamber, liquid return hole, gas-liquid separation chamber and so on.

        Pump normal starting, the impeller room will suck the liquid suction pipe and the air suction, and can be fully mixed in the impeller under the action of centrifugal force, the liquid entrainment from the gas chamber outer scroll flow, the formation of a certain thickness of the white foam and high-speed liquid ring in the impeller on the edge. The gas-liquid mixture passes through the diffusion tube into the gas-liquid separation chamber. At this point, as the flow rate suddenly decreases, the lighter gas is separated from the mixture gas, and the gas continues to rise and discharge through the pump body. After the degassing of liquid to the liquid storage chamber, and the reflux hole again into the gas and the impeller, impeller sucked from the suction pipe again mixed in high speed rotating impeller role, and flows to the outer edge of the impeller feels feels feels feels feels feels. As the process goes on and on, the air in the suction line continues to decrease until the gas is exhausted and the self-priming process is completed, and the pump is put into normal operation.

UK GRIMM imported self-priming pump technical parameter:

 

 

Flow rate: 3.2-600m3/h

Lift: 8-80m

Caliber: Inlet diameter: 25-300mm

             Outlet diameter: 25-250mm

Range of suction: 5-6.5m

Self suction performance: 1.3-2.5min/5m

Speed: 1450r/min, 2950r/min

Power: 0.75-132kw

UK GRIMM imported self-priming pump application range:

 

 

1. Suitable for urban environmental protection, building, fire, chemical, pharmaceutical, dye, printing and dyeing, brewing, electricity, electroplating, paper making, industrial and mining washing, equipment cooling, etc..

2. With rocker arm sprinkler, and water can be washed into the air, scattered into small raindrops spray, is a farm, nurseries, orchards, tea plantations good tools.

3. Application of chemical liquid in water, seawater and with acid, alkalinity and general mushy slurry (medium viscosity less than 100 per cent Perot, solid content is below 30%).

4. It can be used in conjunction with any filter press of any type or size, and will be the ideal type of pump for the press filter.

联系方式
公司:上海秉奇阀门有限公司
状态:离线 发送信件 在线交谈
姓名:黄天翔(先生)
职位:经理
电话:021-51698378
手机:13524269805
传真:021-51698378
地区:上海
地址:上海市徐汇区龙漕路51弄
邮编:200235
邮件:bqvalves@126.com
QQ:250996786
发表评论
0评